Hardware Talk: Dillon Wrench Rack Set

by Tommy Grant

The Dillon wrench kit comes complete: All you have to do is assemble it onto your press. They are press-specific, so make sure you get the correct one.

Do you ever say to yourself you’ve had enough? More specifically, have you had enough with the litter of tools on your loading bench?

I have.

I’m regularly swapping toolheads to change calibers on my presses as I test this or that, trying something new or swapping calibers. I tried to keep the Allen wrenches for those adjustments in a plastic box, but they always ended up on the bench.

And then, where on the bench were they? Mumble … mumble … mutter.

I finally had enough, so when I saw the wrench rack from Dillon, I knew my 550 and 750 were each going to get a set. The rack is simple: It’s a heavy-gauge stamping that you bolt to the top back of your strong mount, behind your press. You don’t use a strong mount? We’re going to have to talk about that in the next issue.

Dillon has it all covered. You bolt the plate by means of the rear bolts on your press/strong mount setup. The kit comes with the Allen wrench sizes you need to work on your press, plus a die ring wrench as well. They all slide right into their reserved spots. And, just to make it even easier, Dillon includes a strip of label, with the sizes already printed on it, and they’re spaced to line up with the spot for each of them.

Dillon-Wrench-Rack

Hot tip: Install the label before you bolt on the plate to save yourself the stretching and reaching to get the label in place after you’ve bolted things together.

Wait, there’s more. The wrenches come with the angle to the short leg of each one pre-dipped in vinyl, so you have a good grip and can see the wrench clearly when you go to pluck it out of the rack. As an extra bonus, the working end is a ball-end wrench tip, so you can spin the wrench even when you approach the screw you’re tightening from an angle.

Of course, gear doesn’t come cheap. The kit runs $46 from Dillon.

“Ouch,” you say?

You can buy the wrenches for a buck each. Yes, you can. But then you’ll still have them scattered on your loading bench or in a box you have to find. Once you lose one or use it someplace else and leave it there, you’ll buy another. And another. You’ll end up with three, four or five sets of them scattered to the winds.

With the Dillon kit, you have a place for them. And the Dillon blue vinyl coating lets you know “This is a loading room wrench; I have to get it back there.”

I’m not saying you need to go full-on Marie Kondo on your loading room, bench and components storage, but keeping the tools that get things properly adjusted is a smart thing to do. And when you can make a change by simply grabbing the handy wrench and put it back right where it was, your loading process will be less distracted, more focused and more productive.

Editor’s Note: This article originally appeared in the April 2024 issue of Gun Digest the Magazine.


More On Tools & Gunsmithing:

Read the full article here

Related Posts