The Naval Surface Warfare Center Crane Division last month revealed the service’s new “Drone Killer Cartridge,” or DKC, a small-arms ammunition specifically designed to destroy small quadcopter drones.
In the announcement, Brian Hoffman, chief engineer of NSWC Crane’s Man-Portable Weapons, explained that the ammo works much like a shotshell in that it disperses a cluster of projectiles, but it’s designed to be fired from a service rifle or machine gun instead of a shotgun.
“The intent with our ammunition was to simply give operators a better chance of killing drones with cost-effective products that can be used in existing weapons,” Hoffman said in the release. “If you aren’t the world’s best shot or don’t have a lot of experience engaging aerial targets, your odds go up immediately with DKC.”
The cartridge’s design, coupled with the range and velocity of typical centerfire rifle ammo, increases the probability of “hit and kill” against drones, Hoffman said.
In a recent demonstration at Indiana’s Camp Atterbury, DKC achieved a 92% success rate.
Hoffman explained that the DKC product line is “already mature” and applicable for not just killing drones but also “home defense, personal protection and hunting.”
And if it sounds like he’s pitching the product line, that’s because he is. The other part of NSWC Crane’s announcement is that it’s looking for partners to manufacture DKC ammo.
The tech link
Hoffman explained that the Navy typically relies on the Army for small-caliber ammunition under the Single Manager for Conventional Ammunition directive. However, it procures ammo through government contracts with industry partners if not supported by the SMCA.
For that reason, NSWC Crane’s announcement was also featured on TechLink, a Defense Department-funded organization run by Montana State University that helps businesses license technology from federal laboratories.
Using the website, manufacturers can license and commercialize products, like DKC ammo, which have been fully developed and patented by the federal government. The intent behind the project is to help veterans, the military and small businesses.
As small drones are now seen as a common weapon on the battlefield, military and other agency leaders project needing millions of DKC rounds, Hoffman said.
“Ongoing conflicts abroad and operational requirements along the U.S. southern border highlight the immediate utility of DKC and its enhanced yet cost-effective capabilities,” he said in the release.
Exactly who is going to manufacture the ammo has not yet been announced. However, Hoffman added that NSWC Crane recently hosted a DKC-licensing event attended by several U.S. ammo makers, and they received even more interest because of the announcement.
Still, Hoffman said DKC ammo production will evolve in the not-too-distant future.
“Given projected requirements, meeting total DKC quantities will likely involve a combination of (Government‑Owned, Contractor‑Operated) production and licensed industry partners operating in parallel,” he said.
Read the full article here
